• NEW LOCATION TO BETTER SERVE YOU!

    Please note that we moved on 9/1/14 to a larger facility: 9283 Sutton Place in West Chester, Ohio.

ANSI/SPRI ES-1 Tested

Edge Shield Fascia System

The Edge Shield Fascia system is designed for ease of application while providing strong edge securement of roofing membrane. This cost saving design eliminates the labor intensive splice lap typical of standard gravel stop details. The integrity of the membrane is maintained by means of a continuous base rail which eliminates the need to fasten through the membrane at the roof surface. This system has been tested to meet ANSI/SPRI ES-1 requirements for wind uplift. pds_pdf_icon es-fasciamodel   es-teststamp

Edge Shield Drip Edge System

The Edge Shield Drip Edge System is designed to effectively terminate self adhered or mechanically fastened membrane roofing systems and can be used above gutter as well. This system has been tested to meet ANSI/SPRI ES-1 requirements for wind uplift. pds_pdf_icon es-dripedgemodel   es-teststamp

Edge Shield Gravel Stop System

The Edge Shield Gravel Stop System has been tested to meet ANSI/SPRI ES-1 requirements for wind uplift. pds_pdf_icon es-gravstopmodel   es-teststamp

Edge Shield Moc1 Coping System

(available Flat and Tapered)
The Edge Shield Moc1 Coping System is a time proven and economical design. It incorporates a continuous hold down cleat on the front side and fasteners at the rear. A wood nailer or substrate sufficient to hold fastener at rear face is required. This system has been tested to meet ANSI/SPRI ES-1 requirements for wind uplift. ES-TEST-STAMP

Edge Shield Moc3 Coping System

(available Flat and Tapered)
The Edge Shield Moc3 Coping System is similar to the Moc2 substituting the individual anchor plates with 20 gauge spring plates. This system has been tested to meet ANSI/SPRI, ES-1 ratings. ES-TEST-STAMP

Comments are closed